Date:         Tue, 1 Jun 2004 14:03:40 -0500
Reply-To:     patrick <appin@DISTRIBUTEL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         patrick <appin@DISTRIBUTEL.NET>
Subject:      Transmission
Content-Type: text/plain; charset="iso-8859-1"

I am about to exchange transfer cases from one tranny to another. The tranny on one is shot but the bell housing on the other is cracked. What I would like to do is take the tranny from one and the bell housing from the other and put them together. I am wondering if it is just a matter of removing the four bolts that hold the transfer case to the tranny and rebolting or if there is a lot more to it. I will replace the studs, nuts and and gasket and o-ring. any other suggestions will be appreciated. Thanks in advance, Patrick 85 westy, Appin Ont.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.