Great info. I've been trying to figure out the easy way to do this for some time. Now, is there an existing wire running from the area of the aux battery to the fuse box that can be re used for this purpose? Seems like there would be one. Edward At 07:10 PM 6/7/2004, you wrote: >It is very easy to move that stuff to the aux battery. You don't even >need to pull the fuse block down. Put it back, checking that you did not >loosen any of the connections on the back side. > >All you need to do is remove fuse #3 and LEAVE IT OUT. >Then put a male spade connector on the #12 wire you ran up to that area. >Then plug that male spade into the BOTTOM slot where fuse #3 was pulled >from. >You are done. > > >This only works on 1986 and newer. Be sure to put a fuse on the #12 >wire, right near the aux battery. > >Mark |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.