That metal plate with the hole in the center is supposed to be bent, It fits on both ways the wrong way lets it rattle, the right way keeps it tight. Put the bend back in it and flip it over so it fits flush to the pipe and does not rattle. I expect that's your problem. David
Date: Fri, 11 Jun 2004 21:31:06 -0700 From: Craig Oda <craigoda@GMAIL.COM> Subject: Fridge blowing out. Where to seal air leaks So, I've taken ----Snip------? The plate was bent a bit, so I took a hammer and straightened it. ------Snip------ Do these develop air leaks?
--- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.682 / Virus Database: 444 - Release Date: 5/11/2004 |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.