Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (June 2004, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 11 Jun 2004 13:29:13 -0500
Reply-To:     Stan Wilder <wilden1-1@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1-1@SBCGLOBAL.NET>
Subject:      Re: Felt washer in flywheel, make your own? ... and more
Comments: To: Mike Collum <collum@VERIZON.NET>
Content-Type: text/plain; charset="iso-8859-1"

There atre lots of Graphite impregnated washer used in plumbing fittings. Any one that is dimentially aqcceptable will work. Be sure you polish the dickens out of that main shaft if you don't replace it.

Stan Wilder

----- Original Message ----- From: "Mike Collum" <collum@VERIZON.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Friday, June 11, 2004 12:22 PM Subject: Felt washer in flywheel, make your own? ... and more

> I developed a problem over the winter with the rear of the westy being > covered with oil with what appeared to be a corresponding drop in engine oil > level. I kept the engine oil topped up, but, at highway speeds especially, > the oil mist to the rear must've been nasty for tailgaters. I had a > shuddering clutch when I bought the van but the clutch didn't slip any until > after the oil leak showed up. Then it only slipped when under greater than > normal load. > > Anyway, I found an oily mess in the clutch housing ... but not on the engine > side of the flywheel where I expected to see it. The transmission's > mainshaft is badly scored where it rides in the pilot bearing and I'll be > replacing the shaft and seal. > > All but one of the flywheel bolts came out without a problem, but one was > really buggered up to start with (looks like someone tried to remove it and > gave up). No way was an Allen driver going to grab in this one. Well, a > Craftsman "Bolt Out" #12 did the trick. By the way, instead of a flywheel > lock, I just inserted a Phillips head screwdriver through one of the > pressure plate holes ... through the hole in the engine case and it did the > job nicely. > > I found the pilot bearing to be intact. All the rollers were in place but > not well lubricated. The felt washer and its retainer were missing which > brings me to a question. > > Can a felt washer be fabricated to do the job of the original? > > Thanks, > > Mike > Houlton, Maine > '85 Westy 4 spd > '84 7 pass auto


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.