Date:         Fri, 11 Jun 2004 21:11:24 -0400
Reply-To:     Gilles Turmel <gilles.turmel@SYMPATICO.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Gilles Turmel <gilles.turmel@SYMPATICO.CA>
Subject:      Syncro tranny problem
Content-Type: text/plain; charset="us-ascii"

Hi,
*        I'm finishing the install of a 99 Impreza 2.2L in an 89m Syncro
Westy.  The shift linkage was disconnected at the splined shaft and the
fork.  I've followed the Bentley procedure to adjust that linkage.  It
won't shift in L, 2nd and 4th gear.  Any ideas why?  The tranny is OK.
I've managed to get all gears engaged with the shift selector ball
joint.  Any suggestions on how to adjust that linkage in a more
civilized manner that the Bently suggests.  I don't understand the 23 mm
measure.
*        Best regards.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.