Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2004, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 8 Jun 2004 18:12:07 -0700
Reply-To:     mark drillock <drillock@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         mark drillock <drillock@EARTHLINK.NET>
Subject:      Re: Is John right about the temp gauge
Comments: To: gary hradek <hradek@YAHOO.COM>
Content-Type: text/plain; charset=us-ascii

John is right, but only for 83,84, and some 85 Vanagons. During 85 VW switched to a new "coolant level sensor control unit" RELAY. The new type does not peg the needle on hot when the coolant is low, it only blinks the LED and the needle continues to indicate actual engine temp. Earlier models do both and can cause many tense moments as a result. Both versions can be used in any 83 or newer watercooled Vanagon or Syncro. Water cooled Vanagons prior to 83 do not have a coolant level warning system at all. In 83 they implemented the sensor in the main tank and put the control unit for it in a nice hiding place just below the far left end of the dash. Very hard to find. In 86 they mounted it in the main relay panel where anyone can get to it. The "relay" has a large number "43" stamped on the top. Both versions have this "43" on them. The early version is a little taller. They have different part numbers but can be used interchangeably with different behaviors as noted. I have written about this many times over the years so the archives will contain addition info regarding the differences and the part numbers.

Keep in mind that someone may have already changed the "43" relay so any year can have either type at this point.

Mark

gary hradek wrote: > > John, > Perhaps there a few machines that are wired this > way but it makes no sense. In any case it can easily > be tested by everyone by pulling the wires to the > coolant sensor. My 87 clearly has the coolant sensor > unrelated to the temperature sensor when the coolant > level is low in the tank. The temperature gauge > reads the temperature of the sensor at the thermostat. > If the coolant is hot it reads hot until all the > coolant is gone and then the gauge begins to drop > because there is no hot coolant in contact with the > sensor. I think we need to reconsider what is being > suggested. gary > Date: Tue, 8 Jun 2004 00:29:09 -0400 > From: lauterba <lauterba@BELLSOUTH.NET> > Subject: Re: Overheating problem > > Jack, please note that when coolant sensor thinks > there is low coolant, > the > temp gauge goes to H even though the engine may be at > or even below > normal > operating temperature. > > John > Macon, GA > '84 7-passenger > > __________________________________ > Do you Yahoo!? > Friends. Fun. Try the all-new Yahoo! Messenger. > http://messenger.yahoo.com/


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.