The vanagaon temp gauge is crap..... if you want a good reading of head / engine temp, buy a aircool head temp gauge with sender. there is only 2 reasons that the head gasket did blow over pressure or bad seal of the gasket. -bad sealing head side of the gasket, the use of a recommended sealant is a must...also, if the matting (head side) is to flat ans polish, the sealant won't stick for long.... this surface as to be rough up!!! -Have a coolant pressure test done http://www.benplace.com/pressure_test.htm This will tell you about head cracks or a coolant components failure. And change that extpansion tank cap. All outer aftermarket head gasket i have seen are close to crap, i would only use OEM VW head gasket. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.