Vanagoners, This weekend, I did a compression check on my '90 Westy with 162K miles. Usual procedure, remove all plugs, ground HT lead from coil, block throttle open, remove FI relay and the item I am uncertain about, engine at operating temperature. Bentley, p. 15.20, says oil temp. min. 30ºC (86ºF). Here in this part of Arizona (not even PHX), the temperature is well above that before noon and hotter in the garage where the van was sitting. Anyway, here are the results at ambient temp.: #1=130, #2=120, #3=120, #4=130. Ran the test again the next day after a run up to Sedona and back, and waited for the engine to cool down a little so I could get the plugs out and not burn myself. Results: 125, 125, 125, 140 (in same order as above). I understand a compression test is inconclusive without a leak-down test, and I am not having any problems with the engine (other than normal for it's mileage), but would anyone care to comment on these results, and how hot should the engine be for the test? Thanks, Jerry |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.