Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (July 2004, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 1 Jul 2004 08:07:22 -0700
Reply-To:     Joseph Fortino <fortino1@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Joseph Fortino <fortino1@EARTHLINK.NET>
Subject:      Re: oil idiot lamp lights&buzzes
Content-Type: text/plain; charset=us-ascii

all,

my 1.9l started doing all kinds of nutty stuff, my wiring was cool because i just redid it not to long ago. It would flicker at high speeds then after that just stayed on lucky for me my buzzer does'nt come on just the light ;) anyway I hit pep boyes for a switch they sell me this nascar knock brand that turns out to be poop! get this after putting this in it just stays on, * great * I end up getting the correct VW part and not some knock off and waaaaalaa i'm okie now. ( so much for tring to get non VW stuff at the local flaps.

Joe

-----Original Message----- From: John Rodgers <jh_rodgers@BELLSOUTH.NET> Sent: Jul 1, 2004 7:01 AM To: vanagon@GERRY.VANAGON.COM Subject: Re: oil idiot lamp lights&buzzes

I've lived through this myself.

Check the wire that goes to the oil pressure sensor located in the engine case near the bottom of the crankshaft pully. Usually when that belt goes, it breaks the wire or separates the connection to the oil pressure sensor.

Good Luck.

John Rodgers 88 GL Driver

Dennis Oost wrote:

> Hello All, > Hoping you can head me in the right direction. > > Here are the stats: > 87 wolfsburg, 2.1 liter, 164k miles, > original heads and gaskets, leaks a little in cold weather > still holds steady mileage at 17-18/gal, good power, climbs hills in 3rd > oil changes every 2 to 3k , using valvoline 20/50 since 120k > > The question: > Lights for alt, oil, and coolant all light at same time, pull over right > away, look into engine an find primary belt in shreds. > Seems to be the obvious solution. > Always carry a spare and tools so I get it changed on the spot. It > starts, everything looks good, as I would expect. > A short way down the road oil light comes on with the warning buzzer > again, shut it down and pullover. Everything "looks OK". I start and the > same thing happens. > Oil level is ok, no oil in coolant, no coolant in oil, I cannot find any > clues. > I start it out of gear and watch, revving the engine and holding it for > a little while, things look and sound OK. > But as soon as I get in and begin driving, oil lamp and warning buzz > engage. > Could it be a faulty sensor? > Dennis >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.