Has anyone experienced leaking of water from the evaporator tray? The shop manual states that to remove the evaporator housing you must start from the front and work to the rear removing the AC ducts, then brace the lower housing with a lift and lower? I have checked the drain tube by blowing from the down end through the flapper gate valve and there is no resistance (ergo clear I guess). So the question is this lift system to lower the evaporator housing... how heavy will the evaporator be? After removing the 3 bolts at the left and right side of the lower housing (also removing the plastic bolts along the rear edge) is it going to want to drop out like an anvil or what? Thoughts comment welcome... Thanks in advance! /Brett 90 - Carat |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.