Balky shifter?!? What a country! You might try putting a little grease on the shifter stops- little ledges in the box that lives under the pivot joint. You can try to hurt your hand getting to them from above, with the shifter removed, or you can try to hurt your hand getting to the from underneath, after you drop your spare. There's also a support somewhat South of there- it has a bushing that can wear out. You can replace it, or try to sneak some lube in there first. -Simon
On Jul 8, 2004, at 7:11 AM, Jim Felder wrote: > My shifter (90 vanagon) has lately started to balk going into first. I > can hear a dry rubbing under the floor where the shift lever pivots > (front) often when I move it. > > From where, top or bottom, should I attack this? what should I expect > to see when I get in? Anything I should probably consider replacing? > > I checked the archives and they were a lot of help for the rear > ball-and-socket, but didn't directly address what lay under the front > floor. > > Thanks, > > Jim > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.