Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2004, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 12 Jul 2004 22:35:32 -0600
Reply-To:     Bob Stevens <mtbiker62@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Bob Stevens <mtbiker62@HOTMAIL.COM>
Subject:      Re: oil coolers, engine and trans
Comments: To: Jonathan Farrugia <jfarrugi@UMICH.EDU>
Content-Type: text/plain; charset="iso-8859-1"

Qualifier: I'm no 'spert on this but am speaking from my own experience and observations. Don't vw trannies usually carry a requirement for 75-90 wgt lubes? Isn't that about 2 times the wgt of engine oils? With my oil cooler, the only thing the thermostat does is turn on the cooling fan. The oil is constantly running up through the cooler and oil lines. My thermostat went out recently so I've bypassed it and my fan just runs as long as the engine is on. My engine oil pressure almost always registers (according to the VDO on the dash) between 30 and 75, depending on engine rpm and cold/hot. I have no idea about tranny lube pressures but am sure others here will. Sorry if this wastes some valuable cyber/archival space. I got my cooler from: http://www.mckenzies.com/catalog/show_products.cfm That's the McKenzies cooler page. I got the Setrab-FP 119 Cooler & Fan They might be a real good resource for your question, too. bob

----- Original Message ----- From: "Jonathan Farrugia" <jfarrugi@UMICH.EDU> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, July 12, 2004 9:32 PM Subject: oil coolers, engine and trans

> does anyone know what the design differences are between engine oil > coolers and transmission oil coolers? i was thinking that the engine oil > coolers might be able to handle higher pressures than transmission oil > coolers can. due to the fact that trans oil is much thinner than the > range of oils that can be used as engine oils. then i was thinking that > the oil cooler isn't going to see any pressure until the oil is at temp, > thats if you are using a thermostat is the system. > > so then i started thinking that i have know idea of how much pressure a > "normal" auto trans pump produces. does anyone know ball park figures for > auto trans pumps and the relative viscosity of trans fluid at temp? do > auto transmissions have a thermostat built in or is oil pump through the > cooling system at all times? i ask all this because i am in the > beginning stages of designing myself a super budget custom oil > cooler system :). > > jonathan >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.