Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2004, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 15 Jul 2004 13:24:57 -0400
Reply-To:     Cory Sammons <slagskot@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Cory Sammons <slagskot@HOTMAIL.COM>
Subject:      Re: Weeping water pump and driver
Comments: To: gary hradek <hradek@YAHOO.COM>
In-Reply-To:  <20040715161444.23313.qmail@web41310.mail.yahoo.com>
Content-type: text/plain; charset="US-ASCII"

> Jeff and Eric, > The main causes of waterpump failure is > almost always too much belt tension. Some failure > can occur because of poor lubrication by the use of > old coolant or water without antifreeze. > Eric has a good point but I think it is a bit > extreme to soak the waterpump for 24 hours. > The seal does not swell but more likely the seal can > burn if you run the waterpunp in a dry condition. A > few turns of the waterpump by hand after adding > coolant to the tank is all that is needed. If you > want to do it eric's way just bleed the next day or 24 > hours later. gary > Date: Thu, 15 Jul 2004 07:26:22 -0400 > From: Eric Zeno <vw4x4@FYI.NET> > Subject: Re: Weeping water pump and driver > > 99.999999999% of all water pumps on vanagons are > install wrong. > IF you read the instructions that came with the pump, > it states > to soak the pump in anti-freeze for 24 hours before > installing. > This is important to insure the seal does not leak > prematurely! > There is an easy way of doing this. Install the pump > dry, fill > with anti-freeze, and before starting, let it sit for > two days. Most > mechanics will not do this only because they can not > afford the time. > > ERic > > Jeff Oxroad wrote: > >> I replaced my water pump with a genuine VW water pump > about 4 years > and >> 30,000+ miles ago. It seems to be weeping coolant > through the weep > hole. Enough so >> that it dimished the coolant level in the overflow > tank. Lets say it > lost >> about 2 cups of coolant. >> >> Seems a rather short run for the water pump--is it?. > The bus does sit >> sometimes for a month at a time. Would this make the > water pump life > shorter? I mean >> c'mon, I just did this job, relatively. >> >> Is some weeping normal? How much time so I have > before it needs >> attention--any? >> >> (FWIW the VWOA water pump I got from VW was from > Italy--I think it > said >> remanufactured in Italy and went for about $110 for > the part from what > I remember. >> Remember when VW parts were made in germany and > lasted?) >> >> TIA >> Jeff >> 83.5 Westfalia >> LA,CA >> > > > > > __________________________________ > Do you Yahoo!? > New and Improved Yahoo! Mail - Send 10MB messages! > http://promotions.yahoo.com/new_mail > Just got a new water pump from bus depot and no mention of soaking Does say to expect a few leaks early on though I plan to treat the o ring like an oil filter and rub a little coolant on before installing


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.