Date:         Wed, 21 Jul 2004 01:12:52 -0400
Reply-To:     tabe johnson <xtabe@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         tabe johnson <xtabe@YAHOO.COM>
Subject:      Rounded CV Joint Bolt - Cutting Slot
Content-Type: text/plain; charset=us-ascii

Hi,

One method I've used with good results is to cut a slot
with a Dremel, then use an impact driver (couldn't live
without it!) with the slotted bit to remove the fastener.

Impact drivers ($10) are great.


--tabe johnson
87 Westy

______________________________________________________________________
Post your free ad now! http://personals.yahoo.ca

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.