I have cracked the cylinder head with an easy-out trying to get a sheered off bolt out of the thermostat housing. I suspect I may have to replace the whole d--n head. I've done a bit of wrenching on Vanagons but never done heads or headgaskets before. I need a good source for a replacement head.?? Recommendations? (as low cost as possible....need to conserver $ on this project) Do I have to replace both...or can I get away with just doing one? Need a good step-by-step on head replacement....any good links in addition to Bentley much appreciated. Warren C. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.