The rear axles need very little service. If you're going to remove the axles this is what I've found best. 1) Go to a truck service mechanic that can break the big nut loose. 2) Leave the nut loose enough that you can get it off yourself, install the cotter key and drive home. 3) Remove the drive axle inner CV from the transmission flange. 4) Remove the stub axle after removing the rear wheels, brake drums. 5) Clean the parts and interior of the axle housing. 6) Repack the bearings and pack the housing. 7) Install new seals. 8) Use only general purpose grease or be certain and buy the specified grease from a VW dealer. (Molybdenum Grease like for front disk brake bearings will turn the rear axle bearings into bushings, don't use it.) 9) Return tio the truck service center and get the nuts properly torqued. 10) These bearings easily last over 100,000 miles if they have lubrication. If you want to install grease fittings this is the time. The problem arriving with grease fitting installation is TOO MUCH grease that will push the seals out and make a big mess out of your rear brakes. You don't really need them if you service the bearings / seals every 100,000 miles. Stan Wilder www.engineceramics.com
----- Original Message ----- From: ". ." <rrecardo@WEBTV.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Sunday, August 01, 2004 11:28 PM Subject: hello and a new memeber.
> I have been reading the vanagon.com archves for some time and heve not > found any answer's to a question I have. > I would like to remove the rear stub axles and service the rear > bearings. > I am finding out that a regular service schedule on the rear axle > bearings will be an unpleasant task. > The stub axle will have to be removed along with other items. > Not a savory task. > I had in my mind to drill and install a grease fitting into the stub > axle so at least once a year I could give the bearings a bit of high > temperature, no washout, heavy duty grease just to make sure that they > are properly lubricated. > Does anyone out in the list see any problems with this modification the > rear axles? > > Thank You, > R. Recardo |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.