Date:         Mon, 2 Aug 2004 18:58:06 -0500
Reply-To:     Stan Wilder <wilden1-1@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1-1@SBCGLOBAL.NET>
Subject:      Re: hello and a new memeber.
Comments: To: Ken Lewis <kdlewis_wasting_time@ACCESS4LESS.NET>
Content-Type: text/plain; charset="iso-8859-1"

You've got me confused.
I have ground off the big nuts at wrecking yards and pulled the stub axle
and drive axle with both CVs still on the axle.
The axles just drop below the tranny if it's there and you pull the parts as
a unit. It saves loosetning the outer CV bolts that are often a beatch to
remove.

Stan Wilder
www.engineceramics.com


----- Original Message -----
From: "Ken Lewis" <kdlewis_wasting_time@ACCESS4LESS.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Monday, August 02, 2004 1:59 PM
Subject: Re: hello and a new memeber.


> I was unable to remove the drive axle while still attached to the stub
axle
> if that is what you are implying.
>
> Ken Lewis
> 86 Transporter Crew Cab
> 60 356 T-5 Porsche
> http://neksiwel.20m.com/
> Vanagon tech, pixs, O2 monitor gadget
> ----- Original Message -----
> From: "Stan Wilder" <wilden1-1@SBCGLOBAL.NET>
> To: <vanagon@GERRY.VANAGON.COM>
> Sent: Monday, August 02, 2004 9:02 AM
> Subject: Re: [VANAGON] hello and a new memeber.
>
>
> > 3) Remove the drive axle inner CV from the transmission flange.
> > 4) Remove the stub axle after removing the rear wheels, brake
drums......