Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2004, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 3 Aug 2004 10:56:02 EDT
Reply-To:     Shultze@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Ed Shultz <Shultze@AOL.COM>
Subject:      Re-time after replacing temp2 Sensor and coolant???
Content-Type: text/plain; charset="US-ASCII"


Hi folks,
First, I have an '87 2.1L van.
My temp gage has been acting flakey for a while now. I replaced the coolant,
thermostat, and while I was at it, replaced the tempII sensor. Now van won't
idle, it's very rough. Stalls like its not getting any gas, any RPM below 2000
is very rough, I almost got stranded.


The engine stalled while I was reving it up approx. 2,000RPM to replace the
coolant. From then on, it keeps stalling.


Do I need to re-time the motor due to the new temp II sensor?
Maybe a bed temp II sensor?


Any suggestions?


Thanks,


-Ed
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.