Hi Volks, One more bit of advice here.... pulling fuses is certainly a good place to start, but there's no guarantee that the problem is on a fused circuit. There are lots of places where an accessory could be installed upstream of the fusebox with a fuse of its own. If the current drain isn't detected by pulling fuses you will need to look for problems upstream of the fuse box: - Look for extra wires heading from the battery to power auxiliary components, esp. radios or heaters. - Wires leading from the hot side of the fuse box may also have been added to power some accessory or other. Also: - Make sure the battery is completely clean... if the top is contaminated and damp it's possible there could be a small loss there. Most of the time these problems seem to come from accessories... fridges, radios or anti-theft systems. Happy trails, Greg Potts Toronto, Ontario, Canada 1973/74/79 Westfakia Conversion **Bob the Tomato** LY3H 1977 Sunroof Automatic L63H/L90D http://www.pottsfamily.ca/westfakia http://www.busesofthecorn.com
On 16-Aug-04, at 12:26 PM, Neal Hansen wrote: > You don't need a current meter, you can use a small 12 volt lamp bulb, > such > as a dome light in line with the battery. When the light goes out you > have > cleared the short. > Neal- > ---------------------------- > > Date: Mon, 16 Aug 2004 10:55:13 -0400 > From: Eric Zeno <vw4x4@FYI.NET> > Subject: Re: Short in Electrical System > > Put a current meter in line with the battery. Then start pulling > fuses. This will isolate the circuit. I have the same problem > but "no time to kiil" . Let me know what you find. > ERic > > Warren Gaylor wrote: > >> Hi Fellow Westy addicts- >> My 91 westy's battery is completely drained after not being >> driven for > a >> couple of weeks, the battery is less than a year old and when put on >> the >> charger comes right up to fully charged. Any ideas how to start >> checking > where the >> short may be? I think this is a fairly new problem as it has been not >> used >> for several months in the past with no hesitation on starting. I had >> to > have a >> new A/C compressor installed and this problem has seemed to have >> started > after >> this work was done, however all the connections there look okay, >> Any Ideas? >> Thanks >> Warren & Geranium the Fourth >> >> >> > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.