Greetings listees!
I'm in the process of rewiring the 14 pin connecter in my 83.5 wasserwesty to install the new, later-model, tach-equipped instrument cluster I acquired from Chris. I've been following the circular wiring schematic I found in the archives. I have a couple of questions for those more knowledgeable or better able to decipher Bentley than me:
1) The red/white wire that used to connect to pin 12 is for what? And should it really be left disconnected???
2) There was no blue/green wire attached to pin 11 when I started moving wires around. According to the Bentley wiring schematic this is for the OX SNSR ELAP MILE SW or something like that.. I seem to remember something about only Californian vans having these, is this true?
Thanks for any help or clarification you can give me.
Kirk Hockin '83 Westy "Ariolimax" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.