I have an aftermarket gauge that i want to read lower, how do I make it happen, do you use a resistor in line? it is a 12volt water temp gauge, that i am using as an oil temp gauge, that I wish read about 1/3 lower, the upper end is where is reading and once i use the ir thermometer, i will know what is what, but with my eyes, i need the gauge to read a little lower.. any ideas??? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.