Greetings listees, I'm in the midst of attempting to install a Hellroaring Technologies non-diode battery isolator in my 83.4 wasserwesty. You can check out their website here http://www.hellroaring.com/rv.htm (the second diagram, the 'Basic Auxiliary Battery Isolation is the one I'm using) to see their suggested install diagram. Essentially the isolator is supposed to attach to a fuse from the alternator (as do all the vehicle loads such as headlights et al.) on one side as well as to the positive side of the Aux battery, with a fuse in between. This all makes sense to me. Where I need some help is locating the appropriate places to wire into the Vanagon Westy... Do the positive cables attached to the Batteries have fuses on them (other than the fuse panel) or would I be better to add fuses (if so, what amp rating)? I'm not terribly proficient at interpreting the physical locations of wires and fuses and such from the Bentley wiring diagram. Any help would be much appreciated! Cheers, Kirk Hockin 83.5 westy 'Ariolimax' |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.