Date: Wed, 1 Sep 2004 17:37:15 -0500
Reply-To: Jim Felder <felder@KNOLOGY.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jim Felder <felder@KNOLOGY.NET>
Subject: Re: Westy fridge fan--look around
In-Reply-To: <41364DFE.4000200@cox.net>
Content-Type: text/plain; charset=US-ASCII; format=flowed
A while back I replaced such a fan. I was going to buy the gowesty kit
for $35, if memory serves, but I happened a gowesty store on ebay where
they were offering the fans for a LOT cheaper. that was about 3 hard
drives ago so I no longer have any remnants of the transaction to help
you with, but you might look around on ebay to see if they or someone
else has the fans. I think I ended up paying $10, and although you
couldn't tell it was a gowesty store right away it seem that I got
their order desk when I called with a question. Anyway, some connection
like that.
It works well.
Jim
On Sep 1, 2004, at 5:32 PM, Mark Drillock wrote:
> I would hesitate to make any shrouding as it would likely cause the
> fridge fan to run more often than otherwise.
>
> The best replacement fridge fan I have found is the one sold at most RV
> supply places. It used to be sold as a FridgeMate but now is sold by
> Valterra and called a FridgeCool Vent Compartment Coil Fan.
>
> It fits in the stock location and moves a little more air than the
> stock
> fan, especially the early stock fans such as likely came on your 82.
> The
> early ones had a current limiting resistor wired right next to the
> motor. That kept the fan speed down and caused the fan to stay on
> longer
> than it would have at full speed. You did not leave the resistor in the
> wiring when you put in the muffin fan did you?
>
> The Valterra fan kit is overpriced and comes with a couple parts not
> needed that add to the cost. It includes a temp switch to cycle it on
> and off automatically but the Westy fridge already has that. It also
> comes with an on/off switch and switch mounting plate, as well as a lot
> of wire so the switch can be mounted where desired.
>
> The only parts of the kit that I use are the fan bracket, fan motor,
> and
> fan blade. The kit is about $35 USD. The bracket needs 2 new holes
> drilled into the back of the fridge as the stock bracket mounting holes
> don't line up. This is no big deal.
>
> Mark
>
> Alistair Bell wrote:
>
>> couple of things not covered in last posting...
>> .......
>>
>> only thing i want to do after this trip is to replace fridge external
>> cooling fan with one that moves more air. I stuck a smallish muffin
>> fan
>> back there replacing broken stock unit, and in the warm temps we had
>> the new fan ran almost all the time during the day. Doesn't move
>> enough
>> I suppose. A while back a fellow list member raised this concern about
>> muffin fans, now I have to agree with him. Mind you it was hot on this
>> trip, but temps were those that could be expected elsewhere in the
>> world :) Also thinking about Dennis Haynes old suggestion of making a
>> shroud around cooling fin area to direct the cooling air more
>> efficiently.
>>
>
|