Date:         Wed, 1 Sep 2004 08:48:08 -0400
Reply-To:     Mark Cumnock <kayakwesty@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Cumnock <kayakwesty@YAHOO.COM>
Subject:      gauge mod help

I have an aftermarket gauge, that i am wanting to make read 1/3 lower . I
got a water temp gauge, and I am using it as a oil temp gauge. I would
like for it to read a little lower, the upper end of the gauge the number
are low, so the gauge almost pegs out.

Do you install a resistor in line with sensor, what size resistor would it
take.

Hope someone has a clue on this ......

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.