Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2004, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 18 Sep 2004 20:57:19 -0400
Reply-To:     Mike Collum <collum@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Collum <collum@VERIZON.NET>
Subject:      Re: Shaft off to replace 1 cv?
Comments: To: SPENCERVW@AOL.COM

You can certainly take the old CV joint off the shaft and put a new one on ... but you need to remove the shaft from the van first. Here's a link to Tom Carrington's article on CV joint servicing:

http://volksweb.relitech.com/cvjoints.htm

Mike

> Anyone know if it Is possible to replace the outter CV without removing the > shaft? If so how? I see the shaft with both CVs is available from the Bus > depot but only for manual trans. Is the same available for the auto? Thanks all. > Spencer > 85 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.