Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2004, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 2 Oct 2004 16:57:05 -0400
Reply-To:     Angus Gordon <agordon@BRIGHT.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Angus Gordon <agordon@BRIGHT.NET>
Subject:      Re: Fuel pumps
Comments: cc: Al and Sue Brase <albeeee@MCHSI.COM>
In-Reply-To:  <415F0440.9040902@mchsi.com>
Content-Type: text/plain; charset="us-ascii"; format=flowed

Al wrote: >I'm adding an intake filter just as soon as I can find one with 7/16" >inlet and outlet.

Seems the rusty fuel tank/blocked fuel pump is a common phenomena. Late model Vanagons could use a filter ahead of the pump like their older brethren. Here's my experience -

Shortly after buying my '89 Carat I put a bottle of Techron (injector cleaner) in the tank before a long trip. The trip was cancelled, and the bus sat for a few days with a full tank of gas (and Techron). Instead of cleaning my injectors, it went to work on the inside of my tank.

The first symptom was a slight whine from the pump, and a day or so later my wife reported the engine wouldn't run over 4000 rpm (not a bad thing I told her!).

I pulled the pump off and found the inlet side completely gummed up with loads of reddish brown rust gunk. There's a screen on the inlet side of my pump (and all the late model pumps I've checked) which is the second line of defense in keeping the pump clean. The first is the tank outlet screen.

The best solution would be to change the tank, but being cheap I drained the tank, blew compressed air back through the outlet to clear the screen, cleaned the pump and added an inline filter ahead of the pump. The tank outlet is 11mm (about 7/16") as Al noted, and I couldn't find filters in this size so I forced a 3/8" fuel line on the outlet side of the tank and used a NAPA 3002 filter. This is a clear plastic filter so I can keep an eye on it's condition. I also changed the stock Bosch filter after the pump.

Initially I had to change the inline filter after just a few hundred miles as the tank kept expelling it's load of rust, but the interval increased rapidly. Now, 4 years and 60,000 miles later the pump still works fine and I'm reminded by all the problems on the list, to check my fuel filter. It looks a little cloudy, and according to my records it has 12,000 miles on it, so I'll invest the $3.79 and put a new one on. Cheaper than a new tank.

Angus

================================ Angus Gordon '89 Carat NW Ohio '86 Syncro


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.