Date:         Fri, 1 Oct 2004 01:48:52 EDT
Reply-To:     THX0001@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         George Goff <THX0001@AOL.COM>
Subject:      Re: Home Made Bull Bars--Pipe Benders
Content-Type: text/plain; charset="US-ASCII"

In a message dated 9/30/04 6:31:22 PM, gary2a@TELUS.NET writes:

<< You

can also use weld elbows and piece the whole thing together, no bending

required.

. . .  Also, all the bends

will be either 90 or 45 degrees.  This does not look correct. >>

This is not correct.  While in an ideal world all fit-ups would be made with
90's and 45's, the nice thing about butt weld ells is that they can be cut to
any amount of sweep from 1 to 89 degrees.

George

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.