Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2004, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 1 Oct 2004 18:48:22 -0400
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Cheap, sturdy magnetic base for 12v fans
Comments: To: Gnarlodious <gnarlodious@EARTHLINK.NET>
In-Reply-To:  <BD831B34.5BD08%gnarlodious@earthlink.net>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 16:33 10/1/2004, Gnarlodious wrote: > What you get is a torus shaped magnet of any size you can scrounge, some >huge, some small. The largest is 4 inches in diameter. I have several in my >van for keeping track of things, including a homemade cupholder stuck to the >dash.

There are a couple of small but *extremely* serious magnets in every modern hard drive -- you'll find them stuck to the inside of the steel cage surrounding the "voice coil" attached to the head arm. They used to glue them on, but I don't think they typically bother anymore, having them stay put is really not an issue. In fact they may well be holding the whole cage together. Couple of those inside a Kleenex box will nail it right down....

The ones in notebook drives are probably about 3/4 x 3/8 x 1/8 or so, curved to match the sweep of the coil. Nickel plated or coated with epoxy or some such, as they really don't want little magnet chips getting loose.

T-6 or maybe T-5 driver is pretty likely for getting the notebook drives apart. Nokia 5100/6100 phones are T-6 so places that sell customizing gear for them will have T-6 drivers for sale (and Home Depot has two Husky (house brand) combination drivers -- Red top is #1, 0, 00, 000 Phillips and 1/16, 5/64, 3/32, 1/8 flat; Black top is T4, 5, 6, 7, 8, 9, 10, 15. Excellent, if you modify them by tossing out the internal divider so all four bits can stow inside. Not free, but perfectly reasonable for the quality.

Also -- the platters on any hard drive are *extremely* flat -- the head flies a few micro-inches off the surface -- and have hard reflective sputtered surfaces*. Modern ones are quite likely glass as aluminum wasn't stiff enough. Also the rings separating the platters are excellent small parallels (as are wheel bearings on a larger scale). The couple notebook drives I've opened had steel rings, a lot more durable than aluminum.

* Early ('80s) drives had platters spin-coated with iron oxide in varnish just like a tape or floppy.

david

-- David Beierl - Providence RI USA -- http://pws.prserv.net/synergy/Vanagon/ '84 Westy "Dutiful Passage," '85 GL "Poor Relation"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.