Date:         Fri, 8 Oct 2004 07:18:31 -0400
Reply-To:     Darren Lastfogel <dlastfogel@PLYFORMS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Darren Lastfogel <dlastfogel@PLYFORMS.COM>
Subject:      digijet FI adjustments
Content-Type: text/plain; charset="iso-8859-1"

Good morning Listees

Last night I installed new exhaust gaskets because the PO never put any on,
It always ran fine just sounded bad. Now it sounds quiet. This morning I was
on the way to work and it was running very rich then after I turn it off I
could not get the engine to start. My question is where do I adjust the air
to fuel so the engine will lean out? and where is a good starting point?

Darren

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.