Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2004, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 8 Oct 2004 13:53:57 -0400
Reply-To:     Pascal Giasson <pascal.giasson@GNB.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Pascal Giasson <pascal.giasson@GNB.CA>
Subject:      Re: Hose on Fuel Injectors - replaceable?
Comments: To: Taber Johnson <xtabe@YAHOO.COM>

I just replaced my fuel hoses in June and those short ones on the injectors were the ones in the worst condition. I used an exacto knife to slit the old hose as much as I could, then got a third hand (my spouce) and pliers to pull on the hose while slitting some more until it came off. I re-used the original bands. So fare so good. FYI I used the fuel line kit from Van-again which worked out great. Also consider changing the injector seals while your at it, they are very cheap, my old ones were hard.

Pascal '84 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.