Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2004, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 14 Oct 2004 22:37:46 -0500
Reply-To:     Stan Wilder <wilden1-1@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stan Wilder <wilden1-1@SBCGLOBAL.NET>
Subject:      Re: Westy fridge combustion chamber gasket replacement
Comments: To: rrecardo@WEBTV.NET
In-Reply-To:  <25286-416F3EAA-3953@storefull-3172.bay.webtv.net>
Content-Type: text/plain; charset="Windows-1252"

Many years ago, back in 1980 I was a Golf Cart Dealer. I used an International truck with just one single axle under a 40 foot bed. This rig was marginal for transporting 18 golf carts. It had a real bad habit of blowing rear tires because of the overloading factor (I really needed another axle with the 4 additional tires) When I blew a tire I often continued on the remaining inner or outer tire for some miles before I stopped to have the tire replaced. Every time I drove into a truck stop or tire dealer with that remaining tire smoking from the heat they accused me of cooking the tube. Cooking the tube simply means getting the inner tube so hot inside the tire that it welds to the tire and becomes near impossible to remove the tire. To demonstrate their point they'd spray the tire and steam would burst forth from the heat and water stream. The 212 degrees is a minimum to make steam and once you reach 220 you've ruined a tire and tube but you can still get the tire off the rim if you get it dismounted before it cools completely and bonds together as a solid mass. So there you go that's why I say 220 degrees. OH! By the way, I've never been compelled to fry a tube on my stove top to prove my point, but you can if you want.

Stan Wilder High Performance Ceramic Coatings www.engineceramics.com

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Robert Cardo Sent: Thursday, October 14, 2004 10:06 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Westy fridge combustion chamber gasket replacement

Mr.Wilder, Please develop on how you came up with the erroneous 220 degree (?) figure on a truck inner tube. You had one baking in an oven? I can hardly wait for the answer.

RC

--- Incoming mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.776 / Virus Database: 523 - Release Date: 10/12/2004

--- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.776 / Virus Database: 523 - Release Date: 10/12/2004


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.