Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2004, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 25 Oct 2004 17:07:23 -0700
Reply-To:     Tom Young <tomyoung1@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tom Young <tomyoung1@COMCAST.NET>
Subject:      Calif Smog Issues
Comments: To: type2@type2.com
Content-Type: text/plain; charset="iso-8859-1"

Hi all:

Took my '82 (Federal) to a Test Only station and failed fairly significantly in the Hydrocarbons (HC) and Carbon Monoxide (CO). I'd installed an O2 sensor in the crossover pipe but was getting very funky readings from the sensor so after failing Smog I took the vehicle to a local VW dealer and had them set the basic air/fuel mixture, which they did. Went back to the Test Only station and tried again. This time the HC was OK but the CO was still too high.

The engine is, I think, mechanically sound and the ignition components are all in order with fairly new plugs, wires, distributor cap and rotor. I've also installed a Pertronix ignitor. The catalytic converter is new. Did the oil change thing, brought the car in hot, etc.

Question 1: At this point, it seems like the mixture is still too rich and the answer is to continue leaning it down. Agree?

Question 2: Since the VW dealer isn't a Test Only station and can't test emissions on a dyno like the Test Only stations do (I'm told the stress of running on the dyno tends to push up the pollutants as compared to the static idle and unloaded 2000 rpm tests) how the heck do you get adjustments done without just going back, and going back, to the Test Only station?

Question 3: I've got my O2 sensor installed in the "J" bend of the crossover pipe, shortly after the connection to the left-side heat exchanger. Even after VW set the basic mixture I'm still getting anomalous readings. Sometimes when I hook up the voltmeter the reading will be "high" (like .710) and slowly drift upward. Sometimes the reading will be "low" (like .387) and drift downward. I've watched the voltage move up (and down) across the .5 volts reading and it's very languid and constantly up or down without the rapid up and down fluctuations I'm accustomed to seeing on my California vehicle. (I've used the O2 sensor in the California vehicle many times to adjust the basic mixture.) This is with 3 different O2 sensors, 2 of them new. Does any of this suggest some fundamental problem that I've overlooked?

TIA. --------------------------------------------------- Tom Young Lafayette, CA 94549 ---------------------------------------------------


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.