In a message dated 10/31/04 5:18:48 PM, rdh24@CORNELL.EDU writes: << Upper ball joints -- how the heck do you get these suckers out of the steering knuckle? >> Robert, I am not certain how well this will work with the steering knuckle in place, but the upper ball joint can be freed easily with a smart blow to the stud. I use a 2 lb. hammer and a piece of 1'' brass round bar stock for a drift and I give the stud a pop. The taper fit releases instantly. Save the pickle fork for roasting marshmallows; I'm not a fan of pickle forks even for tierod ends. George |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.