Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2004, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 30 Oct 2004 18:35:22 -0400
Reply-To:     Dennis <guskersthecat@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis <guskersthecat@YAHOO.COM>
Subject:      Re: What is that strip?
Comments: To: Robert Cardo <rrecardo@WEBTV.NET>

Mr Cardo, had you taken a moment to read the post properly, you would have noted that the "Marks Brothers" were installing the rear glass using a new rubber seal with NO trim. As you are no doubt aware, they can be purchased with or without the rubber channel for trim. There was no bead locker to remove.

As I mentioned in the post, removing the trim without adding a filler, is a mistake. There would be no problem in removing the trim and adding a similar sized filler.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.