Hi all, I just pulled the clutch and flywheel off of Bill Bones to replace the flywheel seal. I pulled the flywheel seal out and two washers were loose back there. One appears to be a thrust washer with a tab on it, while the other is a flat washer with markings on it. I have replaced a flywheel seal before on my 81 aircooled, but I have never seen two loose washers back in there. What gives? Do I just push them back on there and button it up? Many thanks! Warren Lail 88 Westy "Billy Bones" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.