Date:         Wed, 3 Nov 2004 11:52:23 -0600
Reply-To:     Jim Felder <felder@KNOLOGY.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <felder@KNOLOGY.NET>
Subject:      Repair stands and measurement distortion
In-Reply-To:  <C05B3276-2DBC-11D9-B8A0-000A959B3796@knology.net>
Content-Type: text/plain; charset=US-ASCII; format=flowed

Maybe on this list, maybe at Yahoo Diesels, there was discussion of
whether or not block
measurements could be distorted if the engine was in a stand when the
measurement was
taken.

See Bentley 13.29 Diesel pistons/rings, warning is at the bottom of the
page.

Jim

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.