Hi! I am in the process of tinting my windows. I removed them all from my Syncro. I did the back ones, but now I am confused about the sliding windows. The middle window has two sections. One is a fixed window about half way through, and the other section is the sliding window. Is there a way to remove the sliding window itself from the assembly? Or should I just do it in place and hope that the paper will not jam when I slide it? Any feedback from people who have done it would be greatly appreciated. thanks Christian thanks Christian
--------------------------------- Do you Yahoo!? Check out the new Yahoo! Front Page. www.yahoo.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.