Date: Wed, 10 Nov 2004 14:23:43 EST
Reply-To: FrankGRUN@AOL.COM
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Frank Grunthaner <FrankGRUN@AOL.COM>
Subject: On the issue of Speedometer Cluster Repair
Content-Type: text/plain; charset="US-ASCII"
I've seen several posts about the reoccurring theme of repairing cracked and
fully broken Vanagon speedometer clusters. Of course there is much on this
topic in the archives, but I thought I'd call attention to methods I've used for
years to address this problem. Many forms of epoxy (including 5-minute,
30-minute, epoxy strips, gas tank repair epoxy and JB Weld to cite a few) have been
used with varying degrees of success. Success being defined as delamination
within 30 days of reassembly. Very often it is just the screw retention areas
that need to be rebuilt.
The cited approach of using clear strapping tape to retain the epoxy and act
as a mold is very sound, in that the residual internal surface adhesive will
act as a release agent for the cured epoxy.
On the issue of screw hole repair, long ago I used JB Weld (various curing
times and viscosity's) for this purpose. I imbedded the required screws in the
remaining screw threads after first coating the screw body with WD40, then
built up the required support area with the epoxy. I always buff the outside of
the remaining vanagon plastic bezel with 1000 grit wet/dry cloth to promote
adhesion. I always run the epoxy repair over the outside edge to increase
strength. After curing, the screws readily turn out for release and draw down tightly
for reassembly.
On the tie down flange of the cluster to the dash metal, I used to incur
broken bits that were very annoying. My solution was to cut two thin aluminum
(about 1/16 inch sheet) strips to reinforce the plastic tabbed flange. The top one
was slotted to slide over the reinforcing ribs and opened for the screw slots
as was the lower piece. After a thin coating with JB Weld (again), I clamped
the pieces together for curing. A quick touchup with the dremel tool gets rid
of interfering epoxy and clears the mount holes. The net effect is to raise
the cluster by about 0.040 inches (1 mm). Acceptable for this level of
technology in my view.
BTW, I rarely see this cracking phenomena on any other VW clusters in the P&P
yard.
Frank Grunthaner
|