Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2004, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 20 Nov 2004 22:16:40 -0500
Reply-To:     Scott Norville <KR2NO@EARTHLINK.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Norville <KR2NO@EARTHLINK.NET>
Subject:      Re: flywheel bolts stuck

On Sat, 20 Nov 2004 21:58:37 -0500, Ken Lewis <kdlewis_wasting_time@ACCESS4LESS.NET> wrote:

>Scott, > If you drill the heads off the torque will be released so the remaining >bolt should, theoretically, come out easily. > >Ken Lewis >http://neksiwel.20m.com/

Yes, but I am also concerned about Loktite and corrosion. I have some easy-outs but it looked tight to get them around the bolt-head. I'll give it a look in the morning.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.