Date: Sat, 20 Nov 2004 00:10:13 -0500
Reply-To: Benny boy <huotb@VIDEOTRON.CA>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Benny boy <huotb@VIDEOTRON.CA>
Subject: I have a dificult one (Very thecnical/Aircooled) NVCBBC
Good day guys, i hope you can help me....because am very confuse in regard
of a valves adjustment on an engine that am re-sealing!!!
Here is the deal, it all began when we thought (customer and me) i was
working on a 2.0L 78 engine with hydro, along the way when the heads were
out and i had to remove a lifter wile changing the pushrods tubes O-Ring,
after many measurement:
Valve diameter = 41mm intake / 34mm Exhaust
Bore and Stoke = 93mm bore / 66mm for stroke
Case = AW014863
Head # = 021-101-371S (still not sure of those number????)
Anyway, to make a very long story short, wile i was almost done with this
engine, it was time to do the valves as i know now that i have solid lifters
(i know Vanagon lifter, i hope that Bus's hydro lifter are the
same?????).... so like always, 006 on #1 and up to #2 but????????????????
Now that am on #2, intake valve on #1 as now a 1/8in gap????????? anyway, as
i try to do all other valves and cylinder, i found that all valves are way
to tight (like if this was hydro lifter - 1 turn in), so i do all the valves
to 006 anyway...
Here is my problem: as soon as i move to the next cylinder, the one before
end up with a very loose valve (Mostly intake except for #2), that loose is
at least 1/8in????? So i say to myself, something is really wrong here, so i
double check the TDC on #1 (visual piston position, pulley position on "0"
and distributor position on #1 and on notch) Everything is fine, i even
check the cam lobe position though the lifter hole (looks fine to me but
difficult to be sure) So i go to a 1.7 am bulding right now , the core is
not close so i compare the lobe position with both engine, they looks OK to
me, but am not sure!!!!
My conclusion: Well, i have none! the only thing i can see is a wrong cam or
a offset cam position....i don't know what to think.....
Thank a million for any advices!!! Am lost here..... and very tired.
Regards, Ben
ps.: here is the engine project web page:
http://www.benplace.com/type2_engine1.htm
|