Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (November 2004, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Mon, 29 Nov 2004 16:07:46 -0600
Reply-To:   John Rodgers <inua@CHARTER.NET>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   John Rodgers <inua@CHARTER.NET>
Subject:   Re: diagnosing CV Q's
Comments:   To: Michael Rule <manikmike@YAHOO.COM>
In-Reply-To:   <20041129202751.11243.qmail@web11207.mail.yahoo.com>
Content-Type:   text/plain; charset=windows-1252; format=flowed

CV's on their way out will usually make a clicking or clacking sound. You can test for it by getting in a big parking lot, turn the steering wheel to the stops, then drive the vehicle in a circle, first one way, then the other- ever with the wheel to the stops. This will work most of the time, though not always. Then check the CV bolt torque -- again. One thing that can give a false warning of iminent CV failure is two or more bolts being loose, while the rest are tight. The CV will move just enough to pop the vac of the CV against the face it normally is flush against. This will make a clicking or popping sound.

Vibration at high speed is usually something else, most notable possibility is tread separation. Pull the suspected tire and have it run on a balance machine at a tire shop. It should show up. I had four Michilins on a Jeep wagoneer have tread separations all at once - four tires. It was a major consternation for me and the dealer. Got new tires.... went to Goodyear - no more tread separations. This happened in Alaska 15 years ago, so no telling what the problem was. Old tire rubber, maybe. Who knows.

Good luck.

Regards,

John Rodgers 88 GL Driver

Michael Rule wrote:

>Hi All, > >question regarding possibly failing Vanagon (et al) CV's: > >Would a CVjoint on it's way out vibrate at higher speeds, perhaps as a >prelude to that nerve-wracking click-clacking that typically precedes >failure? > >I have a new vibration that seems to be coming from the van rear; tire >balance seems to have been ruled out by the shop. Bolts are torqued >properly. > >Also- when checking, I am not sure if I should have the wheel on or off >the ground? > >I'm half tempted to remove an axle so I can get a good look at the >CVjoint to better understand how it works- but I'd rather save my >energy for if/when it goes! > >Thanks for any help/suggestions, >Mike >84's > > > >__________________________________ >Do you Yahoo!? >All your favorites on one personal page – Try My Yahoo! >http://my.yahoo.com > > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.