Date: Mon, 29 Nov 2004 16:09:18 -0700
Reply-To: jimt <wetwesty@TACTICAL-BUS.INFO>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: jimt <wetwesty@TACTICAL-BUS.INFO>
Subject: Re: diagnosing CV Q's
In-Reply-To: <41AB9DB2.3070400@charter.net>
Content-type: text/plain; charset="ISO-8859-1"
On 11/29/04 3:07 PM, "John Rodgers" <inua@CHARTER.NET> wrote:
> CV's on their way out will usually make a clicking or clacking sound.
> You can test for it by getting in a big parking lot, turn the steering
> wheel to the stops, then drive the vehicle in a circle, first one way,
> then the other- ever with the wheel to the stops. This will work most of
> the time, though not always. Then check the CV bolt torque -- again. One
> thing that can give a false warning of iminent CV failure is two or more
> bolts being loose, while the rest are tight. The CV will move just
> enough to pop the vac of the CV against the face it normally is flush
> against. This will make a clicking or popping sound.
>
> Vibration at high speed is usually something else, most notable
> possibility is tread separation. Pull the suspected tire and have it run
> on a balance machine at a tire shop. It should show up. I had four
> Michilins on a Jeep wagoneer have tread separations all at once - four
> tires. It was a major consternation for me and the dealer. Got new
> tires.... went to Goodyear - no more tread separations. This happened in
> Alaska 15 years ago, so no telling what the problem was. Old tire
> rubber, maybe. Who knows.
>
> Good luck.
>
> Regards,
>
> John Rodgers
> 88 GL Driver
>
> Michael Rule wrote:
>
>> Hi All,
>>
>> question regarding possibly failing Vanagon (et al) CV's:
>>
>> Would a CVjoint on it's way out vibrate at higher speeds, perhaps as a
>> prelude to that nerve-wracking click-clacking that typically precedes
>> failure?
>>
>> I have a new vibration that seems to be coming from the van rear; tire
>> balance seems to have been ruled out by the shop. Bolts are torqued
>> properly.
>>
>> Also- when checking, I am not sure if I should have the wheel on or off
>> the ground?
>>
>> I'm half tempted to remove an axle so I can get a good look at the
>> CVjoint to better understand how it works- but I'd rather save my
>> energy for if/when it goes!
>>
>> Thanks for any help/suggestions,
>> Mike
>> 84's
>>
>>
When the cv are on the rear the normal turn in a circle is not a very
reliable check. This works great for front cv though. The rear cv is more
flexed in up and down motion.
I have found that severely pitted rear cv will give a vibration at certain
speeds. However I have seen rear bearings do the same.
The best way have found for isolating rear cv problems is to carefully
remove and clean to inspect the balls and race looking for pitting and
severe wear and then repack if okay. Sometimes all that is needed is a
repack.
••••••••••••••••••••••••••••••••••••••••
jimt
Planned insanity is best.
Remember that sanity is optional.
http://www.tactical-bus.info (tech info)
http://www.westydriver.com
|