Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2004, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 2 Dec 2004 21:51:21 -0500
Reply-To:     Edward Maglott <emaglott@BUNCOMBE.MAIN.NC.US>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Edward Maglott <emaglott@BUNCOMBE.MAIN.NC.US>
Subject:      Re: Instrument cluster.
In-Reply-To:  <01b401c4d7b3$5fa76420$cb00a8c0@laptop>
Content-Type: text/plain; charset="us-ascii"; format=flowed

You are not the only one. I am having this problem too. I expect I will need a solution to this problem in the next 2 or 3 removals of that connector.

Edward

At 09:38 AM 12/1/2004, you wrote: >My 87 GL Wolfsburg Edition seems to need a new printed circuit board on the >back of the instrument cluster. It is in a bad way where it meets the >connector. I have tried fixing it by resoldering and using copper tape. They >worked for a while but not anymore. Are there other fixes? Am I the only one >with this problem? How much do these printed circuit boards go for and does >anyone have one? > >Thanks, > >Jean-Woo > >----- Original Message ----- >From: "Matthew C. Huntley" <matthew.huntley@STRATHBOGIE.NET> >To: <vanagon@GERRY.VANAGON.COM> >Sent: Tuesday, November 30, 2004 12:32 PM >Subject: Re: 1986 Vanagon GL - Central Locking > > >>Well, the VIN is Higher, so I will check #3. Replacing the other higher >>fuse brought the AC back. >>I am curious, though, since the Lighter is working, so I guess I will >>check it to be sure, and then start tracing wires. Got to find the red >>wire that is the + for the Central Locking Circuit. Maybe it needs to be >>replaced. >> >>Thanks Again, >>Matt >>>>I am trying to troubleshoot the Central Locking that my Vanagon GL >>>>came >>>>with. I have found the actuators in the doors, and I am trying to >>>>find >>>>where the fuse for it is. I have found wiring diagrams that say that >>>>the >>>>fuse for the main power for these doors is 'inline' rather than in >>>>the >>>>fuse panel. Does anyone know where this fuse is located? I am still >>>>waiting for my shop manual, but I am trying to get this fixed >>>>anyway. >>> >>>according to the bentley book, it depends. >>> >>>if your bus VIN is higher than GH055689, your 86 central locking >>>system should be fuse #3 .. the same one as the cigarette lighter. >>> >>>the power WINDOWS have a separate fuse, in a separate holder, just >>>above the fuse box. >>> >>>but if your bus VIN is LOWER than GH055690, your 86 central locking >>>system >>>is a 20amp fuse, in a seprate holder, just above the fuse box. >>>be warned ... the air conditioner is also a 20amp fuse, up in the same >>>place. >>>they don't bother to point out which is which. :( >>> >>>good luck! >>>joel >>> >> >> >>-- >>Any opinions stated here are my own, otherwise someone else would have >>said them. >> >>-- >>Any opinions stated here are my own, otherwise someone else would have >>said them.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.