On 12/12/04 2:59 PM, "Detroit Bus" <detroit.bus@GMAIL.COM> wrote: > Returning to my mechanic, I suggested that either he had (a) switched > the high and low pressure senders, (b) installed two of the same type, > or (c) one or both of the new senders was defective. He will take a > look tomorrow and probably end up ordering two OEM dealer senders > (probably should have done that in the first place...). > > Are there any guesses or advice on which sender is bad, or anything > else that might be the problem? I have seen this problem with two of your options. One of them is the reversed senders. The other is two of the upper senders were used. Assuming the circuit was the same as on jetta/passat et al.
jimt |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.