Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2004, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 12 Dec 2004 06:26:02 EST
Reply-To:     RAlanen@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Frank Condelli <RAlanen@AOL.COM>
Subject:      Re: Power Steering Leak WHERE??
Comments: cc: camealy@CTSR.COM
Content-Type: text/plain; charset="US-ASCII"

In a message dated 11/12/2004 5:15:59 PM Eastern Standard Time, LISTSERV@GERRY.VANAGON.COM writes:

I have had a power steering fluid leak in the engine bay for about 3 years now. Just recently it started leaking very fast. I can't tell where it is coming from because it kind of gets all over. What is strange is the intake hose from the reservoir is soaked the most but that wouldn't have any pressure on it would it? Any help in getting this leak found? I don't want to replace the pump if I don't have to. It doesn't make any noise or have any wobble.

Kurt, probably not the pump. Most likely the pressure hose from the pump to the metal line has a small pin hole or the metal pressure line itself has rusted through but this would not contribute to fluid in the engine compartment. Cut off the rubber shield surrounding the hose and I bet you find your leak. If it is the pressure hose from the pump to the metal line, the one with the banjo fitting it can be repaired by a good hydraulic shop. They will be able to replace the hose on the old fittings with the proper crimp connectors. Since the Vanagon power steering system is high pressure, 1400 lbs, you need to tell this to the hydraulic shop so they will use the appropriate hose and crimps. You can use split loom to cover the new hose or just take a larger diameter hose and slit it lengthways to use as a protective covering. Actually, with good high pressure hydraulic hose I do not see the need for the protective covering. If you need to replace your metal power steering lines that have rusted through see my _Vanagon Power Steering Lines_ (http://members.aol.com/Fkc43/hose.htm) webpage for a good inexpensive soloution.

Cheers,

Frank Condelli Almonte, Ontario, Canada _BusFusion_ (http://members.aol.com/BusFusion/bfhome.htm) a VW Camper camping event, Almonte, ON, June 09 ~ 12, 2005 '87 Westy, '90 Carat & Lionel Trains Member: _Vanagon List_ (http://www.vanagon.com/) , _LiMBO_ (http://www.bcn.net/~limbo/) , _IWCCC_ (http://www.westfalia.qc.ca/) & _CCVWC_ (http://www.ccvwc.ca/) Vanagon/Vanagon Westfalia Service in the Ottawa Valley _STEBRO/Vanagon Stainless Steel Mufflers_ (http://members.aol.com/Fkc43/stebro.htm) _Frank Condelli & Associates_ (http://members.aol.com/Fkc43/busindex.html) or http://frankcondelli.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.