|
Hi Craig, Unless you've disconnected the 2.1L Dynamic oil pressure warning system. The 0.9B switch is needed. It's a ground below 0.9B and an open above it. Without the correct signals the buzzer sounds. If you want access to the oil pressure circuit, go the 0.3B pressure switch on the left side of the 2.1L motor, near the push rods. Install a 1/8" pipe thread Tee using the 0.3B drilling, the 0.3B switch and the new temp sender. It may be necessary to modify the push rod tube splash shield. Home Depot has a full assortment of 1/8" copper pipe thread fittings. Use Teflon sealing tape on threads. Regards, John |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.