Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (December 2004, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 27 Dec 2004 18:18:37 -0500
Reply-To:     ROBERT DONALDS <donalds1@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         ROBERT DONALDS <donalds1@VERIZON.NET>
Subject:      Re: V-Belt Pully Bolt
Comments: To: Al and Sue Brase <albeeee@MCHSI.COM>
Comments: cc: Jim Felder <felder@KNOLOGY.NET>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
              reply-type=response

Al I need a good rod recon man when can you start?

The Vanagon rod has a little more to it than that the small end has a bushing that is replaced when the rod is rebuilt and the rod needs to be checked for twist and bend. 2.1 rods from the factory are dam close in weight and balance and I would not spend a minute with balancing a good used set other than to check the total weights of each. The seasoned rod is my preference because it has been threw the heat cycles proved itself over time rebuilt is better than new depending on who rebuilt it The diesel rods I would rebuild without question because its a diesel. One problem with rebuilding diesel rods is that if they are not the same height when done it can vary the compression. Yes I can speak from experience I had only one diesel rod rebuilt on a 1.6 and the compression was lower on that cylinder because the rod was shorter. fussy diesels Bob Donalds


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.