Date:         Sun, 2 Jan 2005 20:09:12 -0600
Reply-To:     Jim Felder <felder@KNOLOGY.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <felder@KNOLOGY.NET>
Subject:      Re: Headlight switch help
Comments: To: Bob Stevens <mtbiker62@HOTMAIL.COM>
In-Reply-To:  <BAY2-DAV2A389BFA498E5F5C06D7AA5900@phx.gbl>
Content-Type: text/plain; charset=US-ASCII; format=flowed

I lost that right front screw about 10 years ago. It showed up a few
months back when I was doing something under the cluster, I think
gluing on some chipped-off pieces.

Jim

On Jan 2, 2005, at 7:31 PM, Bob Stevens wrote:

> I had that happen too. I took the entire pod out and used a flash
> light and
> found the screw sitting in there. I now use a magnetized screw driver
> for
> these. I was putting white faces on my gauges at one point so had to
> remove
> the pod several times and never had the problem again. It picks up the
> screw
> and washer.
> bob
>
>
> ----- Original Message -----
> From: "jbange" <hfinn@INGRATES.NET>
> To: <vanagon@GERRY.VANAGON.COM>
> Sent: Sunday, January 02, 2005 5:46 PM
> Subject: Re: Headlight switch help
>
>
>> At 10:37 AM 1/2/2005, you wrote:
>>> You can
>>> simplify this a lot, especially getting the switch back in, if you
>>> loosen the whole cluster by taking out the four screw, one in each
>>> corner, that hold the cluster to the dash.  Be careful on this,
>>> especially the screw at the right front, very easy to loose.
>>
>> Speaking of which, I lost that very screw myself last week. Anyone
>> know
>> offhand the size of those screws?
>>
>> What is it with screws like that? I dropped it down the hole in the
>> dash
>> and it vanished forever. No amount of hunting and shaking wire
>> bundles has
>> made it appear. I swear, there's no place for it to go but down, and
>> still
>> it hasn't shown up. I mean, if it was a jesus clip I couldn't find,
>> I'd
>> understand. But this is a fairly good size sheet metal screw!
>>
>> John Bange
>> '90 Vanagon "Geldsauger"
>>
>