On 1/14/05 5:50 PM, "Gerald Masar" <azsun99@EARTHLINK.NET> wrote: > I will be transferring a second propane tank from my '88 Westy to my '90 > Westy, to the > same location right side below the sliding door, and probably have to bend > some new > tubing > to correct PO mistakes (no regulator on #2 tank; just feeds into #1 tank > upstream of > the reg.) > Do the spring-type tube benders work adequately? > > Thanks, > Jerry > > Personally I would not put the high pressure lines for that distance. After reading codes I am not even sure it would be legal to have a high pressure line that length on a vehicle. •••••••••••••••••••••••••••••••••••••••• jimt Planned insanity is best. Remember that sanity is optional. http://www.tactical-bus.info (tech info) http://www.westydriver.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.