I get: 1. 1.7 mm block to start of teeth, teeth width 10.3 mm 2. flywheel diameter 288 mm 3. block to throwout bearing contact surface 82 mm RonC -----Original Message----- 1 On the I5 motors, what is the distance from the block straight out to where starter teeth on the flywheel begins? 2 What is the diameter of the I5 flywheel? 3 What is the distance form the block to the "flat" area where you would push on the clutch fingers with the throw out bearing? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.